In the Windows Installer section of the page, double-click the openVPN-install-xxx.exe link.Visit to download the OpenVPN client utility.Click For Windows to download the OpenVPN configuration files.Specify any VPN service settings on the page.Select the Enable VPN Service check box and click Apply.
Select ADVANCED > Advanced Setup > VPN Service.The user name and password are case-sensitive. Enter the router user name and password.Launch an Internet browser from a computer or mobile device that is connected to your router’s network.
For more information about enabling Dynamic DNS, see How to setup Dynamic DNS on a NETGEAR router using To enable the VPN feature: You must enable Dynamic DNS before enabling the VPN feature. VPN uses a Dynamic DNS account to connect with your router.
You must install the Open VPN software on each Windows computer that you plan to use for VPN connections to your router. The DSL port is shut down.A virtual private network (VPN) lets you use the Internet to securely access your network remotely. The modem router uses the Internet port for an Ethernet The modem router uses the DSL port for a DSL WANĬonnection. Is DSL over the DSL port or Ethernet over the Internet port. The modem router automatically detects whether the WAN connection From the WAN Preference menu, select one of the following options: The user name and password are case-sensitive.Ħ. Enter the user name and password for the modem router. Launch a web browser from a computer or WiFi device that is connected to the network.ģ. To change the WAN connection preference:ġ. Only one WAN interface (either the DSL port or the Ethernet WAN port) can be active at any time. Note: The modem router does not support load balancing over ADSL and Ethernet WAN interfaces. However, you can also set the WAN connection preference manually to either the DSL port or the Ethernet WAN port. The modem router can autodetect the type of WAN connection. (Multiplexing,VPI,VCI are disabled) enable Internet interface only VLAN ID=2, Priority=0 Internet requires login then PPPoE, username with on end, password rest as shown in the screen shot (P63).Ĭhange the Physical WAN Connection Preference Set Country=Australia (if there) Provider=TPG or Other Transfer Mode=PTM DSL mode=VDSL2
Then Specify a VDSL Connection with a Login Requirement and PPPoE Service on P61. See the section Change the Physical WAN Connection Preference (copied below) to use the DSL port. I've taken this description from the guide.Ĭonnect a telephone cable from DSL port to telephone wall socket. Is there someone in the community that has experiance with this router and could support in getting it connected?
With the manual setup failing we tried the Netgear Genie also trying different username/password combinations, if we select the option "no login details required" the router will sync but not connect. In one attempt I manually set the IP and DNS addresses from the working modemĭuring the manual setup I tried different combinations of our username or ) and password ("noPassword",, ).We started by taking all the settings from the working modem and using them as a guide to manually configure the D6400. We used this modem/router a couple of years back with another provider and as part of my troubleshooting this time around I upgraded its firmware from 1.0.0.88 to 1.0.0.102. I am having issues getting a Netgear D6400 to work with TPGs FTTN, the TPG supplied modem worked out of the box but I am keen to swap it over for the Netgear.